Description
1-Hold the HAME MOUNT with your left hand. Place the hook in its clamp as shown in fig. 1, tightening the lock nut between thumb and forefinger. Excessive tightening is not necessary. 2 - Align the HAME MAST as shown in fig. 2 with the jumper in the upper position. Pass the wire around the rear part and then back around the front part. Hold the wire approximately at the angle shown in fig. 2. 3 - Turn the HAME MAST in your hand as shown in fig. 3 (usually 5 turns). Keep the thread taut while winding. 4 - Keeping the wire taut, pass it through the open front part of the jumper. According to fig. 4. 5 - Push the jumper in by pressing the front part with the left thumb. 6 - Loosen the lock nut and pull the wire from the spool again to release the assembly. Cut off the excess wire.